BEAM iSEREIS WebUI - QoS





Summary

With QoS you can prioritize network traffic selected by addresses, ports or services. This chapter is an overview of the QoS function in BEAM SERIES routers.

General settings and Interfaces

The General settings section is used to enable or disable all QoS functionality and the Interfaces section allows you to set up bandwidth limits for specified network interfaces.


GENERAL SETTINGS
field name value description
Enable yes | no; Default: no Toggles QoS functionality ON or OFF
INTERFACES
Interface WAN | LAN | PPP; Default: WAN Interface that the rule applies to
Enable yes | no; Default: no Toggles the rule ON or OFF
Calculate overhead yes | no; Default: no Decreases upload and download ratio to prevent link saturation
Half-duplex es | no; Default: no Enables data transmission in both directions on a single carrier
Download speed (kbit/s) integer; Default: 1024 Specifies maximum download speed for the specified interface
Upload speed (kbit/s) integer; Default: 128 Specifies maximum upload speed for the specified interface

Classification Rules


field name value description
Target Priority | Express | Normal | Low; Default: WAN Target for which the rule will be applied
Source host All | ip; Default: All Host from which data will be transmitted
Destination host All | ip; Default: All Host to which data will be transmitted
Protocol All | TCP | UDP | ICMP | -- custom --; Default: All Data transmission protocol
Ports All | integer [0..65535]; Default: 22,53 Port(s) that will be used for transmission. You can enter multiple ports by separating them by commas (',')
Number of bytes integer; Default: " " The maximum number of bytes for the connection