BEAM iSERIES WebUI - Wake on LAN




Summary

Wake on LAN (WOL) is feature that can "wake up" compliant computers from sleep mode by sending a "magic packet" to the network interface adapter. This chapter is an overview of the Wake on LAN page in BEAM iSERIES routers.

Wake on LAN configuration

You can set up the WOL function to use a broadcast address when waking up devices or wake all connected devices on click from the Wake on LAN configuration section:
 Field Name
 Value  Description
Broadcast yes | no; Default: no If checked, the WOL function sends a magic packet to the broadcast address (FF:FF:FF:FF:FF:FF) whenever it is asked to wake a device. When you send a packet to the broadcast address it is received by all LAN devices.
Wake all devices - (interactive button) Wakes all devices by sending a magic packet to the broadcast address (FF:FF:FF:FF:FF:FF).

Devices to wake up

The Devices to wake up section is used to configure entries for LAN devices that can later be woken up by the WOL function. Refer to the figure bellow for information on the fields contained in the Devices to wake up section.
 Field Name
 Value  Description
Name string; Default: example A custom name for the device. Only used for easier management purposes.
MAC mac; default: 11:22:33:44:55:66 MAC address of the network interface card of the computer that will be "woken up".
Password string; default: AABBCCDDEEFFSecureON Password - sends given password when attempting to wake the host. Some computers have a BIOS feature that secures the WOL feature with a password. If your BIOS does not require such a password, leave this field empty.
Wake on Bootyes | no; default: noIndicates whether the device should be "woken up" on router startup.
Wake device - (interactive button)Sends a magic packet to the specified device.
Delete - (interactive button)Deletes the device configuration.