02 - Logging On

When mTicketr first boots up you will be required to log on with your Driver Pin Code and Vehicle ID.


STEP ONE - ENTER PIN CODE 
Enter you assigned Driver Pin Code using the keypad on the touchscreen. You will then be taken to the Vehicle ID page (see 
image below). 

If your driver Pin Code is not recognised it will turn red and shake prompting you to try again.  


STEP TWO - ENTER VEHICLE ID 
Enter your Vehicle ID using the keypad on the touchscreen.


STEP THREE - CONTINUE 
Once you enter the Vehicle ID tap the Continue button.


ROUTE SETUP 
Tapping the Continue button will progress you to the Route Setup.